TPI THINJOINT E33 – Pre-packaged lightweight brick mortar, cement-based.

TPI Thinjoint E33
Pre-packaged lightweight cement-based mortar for building lightweight bricks.

DESCRIBE

TPI ThinJoint E33 It is a high-quality cement-based adhesive mortar, specifically designed for bonding autoclaved aerated concrete (ALC) bricks, lightweight concrete (AAC) bricks, and panel sheets.

The product contains special additives that provide excellent adhesion and better water retention, ensuring optimal strength development.

APPLICATION

TPI ThinJoint E33 It is used as a thin, high-performance adhesive mortar with water-resistant properties for the installation of ALC and AAC bricks. The product is suitable for both indoor and outdoor applications.

ADVANTAGE

• Easy to use, just mix with water.
• Excellent adhesion strength due to advanced polymer technology.
• Consistent quality
• Convenient for application and mortar mixing. It is not necessary to wet the tile surface before application.
• High durability, resistant to weather conditions.

SPECIFICATIONS

Target	TPI ThinJoint E33
Ingredient	Cement base and additives
Shape/Color	Cement gray powder
Density	1,700 – 1,800 kg/m3
Compressive strength	~ 7.5 Mpa (28 days)
Adhesion strength	~ 0.7 MPa (28 days)
Construction temperature	~ 45 minutes (at a temperature of 27oC/ humidity 65%)
Water mixing ratio	22 – 25% (by weight) ~ 5.5 – 6.5 liters of clean water for 1 bag of 25 kg powder
Standard	A 25 kg bag is sufficient for approximately 9-10 m² of tile.
Output	One bag yields approximately 16.2 liters of mortar. 62 bags are needed to produce 1 m³ of mortar.
Layer thickness	Minimum: 2 mm Maximum: 4 mm
Specifications	25 kg bag
Expiry	12 months (when unopened)
Storage	A cool, dry, shady place.

INSTRUCTIONS FOR USE

Surface preparation:

• The tile surface must be solid, clean, and free of grease, dirt, and other contaminants that could affect adhesion strength.

Mix the products:

• Pour the flour in slowly. TPI ThinJoint E33 Pour 5.5 – 6.5 liters of clean water into a container and mix thoroughly with a hand mixer or mechanical mixer for 3 – 5 minutes until a homogeneous mixture is achieved.
• Let it sit for about 1-2 minutes to allow the additives to react with each other. Then mix again for about 1 minute before use.

Product installation:

• Mortar application TPI ThinJoint E33 Apply mortar to the contact surface of the tiles using a suitable notched trowel. Then spread mortar into the vertical and horizontal joints adjacent to the next tiles.
• The recommended mortar thickness is 2-4mm. Ensure optimal contact between the mortar and the tile surface. Tiles should be laid on the freshly applied mortar as quickly as possible. The tiles can be aligned using a rubber mallet. Do not lay more than two rows of tiles at a time.
• Freshly mixed mortar should be used up within the material's working timeframe.

Toilet:

• Clean tools and construction equipment with water immediately after use.
• The material that has hardened can only be removed by mechanical means.

HEALTH AND SAFETY INFORMATION

Occupational safety and health: Appropriate personal protective equipment, including safety glasses and gloves, should be worn when using this product. It may cause allergic reactions upon contact with eyes, skin, or mucous membranes. Ecology: Do not dispose of into water sources or soil.

Transport: Not dangerous.

Important note

TPI ThinJoint E33 This product is cement-based and therefore alkaline. Appropriate measures should be taken to limit direct contact with the skin. If the material gets into the eyes, rinse immediately with clean water and seek medical attention.